Woodworking can be fun, but it can also be intimidating for novices.

Half Pencil Marks Exact Copies

When trying to draw an exact replica of the plate that is used to create the throat used by a table saw, we discovered this clever method using a pencil. The pencil was simply cut into a half-pencil, using careful grinding with the belt sander. The flat edge allows the altered pencil to travel straight across the top of the templates. It is also great to mark and shape the inlays of woodworking work.

Perfect Bar Clamp Cover

The iron pipe clamps could damage woods that are soft or with glue, causing it to make the wood to look stained. Our suggestion is to cut a portion of plastic PVC pipe into a suitable size and wrap it around the pipe. If you have a few short lengths, it is possible to space them out to allow for various sizes of wood stock.

Quick Blade-Height Gauge

The gauge block can be the fastest method of setting the table saw blade's height. This is made of three inches in length of 4x4 that has been cut to the most commonly used settings. If you require more options, simply create another block.

If it's time to adjust the blade of the table saw, the blocks can help to complete the task quickly.

What's the Reason for Nominal Dimensions?

Many of us felt that the day we realized that a 2x4 is really 1.5 inches by 3.5 inches was awe-inspiring. The reason behind this apparent contradiction lies in the fact that the board was reduced to get rid of any irregularities. In the past years ago, 2x4 were 2 inches by 4 inches. However, the rough surface made them hard to stock and handle. Older words, such as the 2x4 and 4x4, continue to be in use and are referred to by the "nominal" size of the board. The nominal size is employed since they are easy to understand and stick to the old ways of doing things.

A Flexible Sanding Block by the Office

The process of sanding curves is difficult. Sometimes, you require a sanding pad that's strong and flexible. A small notepad can be used. Simply wrap sandpaper around your pad, then bend it into whatever shape you require. The other side of the paper is between pages to keep it to the pad. Give it a go whenever you're working on a task that is curving and has difficult places to reach.

Simple Circle Layout Tool

This simple jig can make laying circles easy. Drill a 1/8-inch hole through each inch line on a yardstick or ruler. For drawing a circular outline, put pins into the number "1" in the center of your board. Add 1 inch to the diameter of the circle you want to draw, then put an eraser into the circle. With the pin acting as a pivot point, turn the pencil to draw the circle.

Make a Quick Mixing Surface

Instead of mixing in a container small amounts of epoxy, you can make an area for mixing on your workbench with painter's tape. Just lay the strips down with the edges overlapping so the epoxy won't get onto the bench. Once you're done, you can peel the tape off and discard it. The mixing surface can be used in many different ways than just epoxy. You can also make use of it to mix wood glue or any other materials you need easy access to while working on projects.

Cheap Stain Sprayer

This is a simpler method to seal or stain lattices, chairs or anything with a lot of recess. Place the stain inside an empty, clean spray bottle. Spray the stain over the work surface and clean up the excess using the help of a rag or brush. The sprayer will spray stain through all the tight, difficult-to-reach joints and cracks.